Cut through almost anything—including thick steel and stone—using the raw power of high-pressure abrasive water. Loaner from Flip Wilson.
⚠️ MANDATORY SAFETY RULES (Click to Expand) ⚠️
- Authorization Required: You must be checked out on the WAZER by a Shop Lead before use. It is a powerful tool that can cause injury or machine damage if used incorrectly.
- Eye Protection: Always wear safety glasses while the machine is pressurized or cutting.
- No Hands in Tank: Never put your hands near the cutting head while the high-pressure pump is active.
- Abrasive Management: Usage of garnet must be logged and paid for/replenished according to current shop policy.
- Material Check: Ensure your material is flat and securely fastened. Bowed material can strike the cutting head and cause a fatal machine error.
| Model | Capacity | CAM Software |
|---|---|---|
| Wazer Desktop | 12" x 18" | Wam Software |
Start Up Instructions
- Check the Tank: Ensure the water level is correct and the tank is free of large debris from previous cuts.
- Abrasive Level: Check the hopper and ensure you have enough garnet for your intended cut duration.
- Secure Material: Use screws to fix your material to the bed. Ensure there is no risk of the material shifting or “tipping” after being cut.
- Set the Offset: Manually set the nozzle height (stand-off distance) using the provided shim tool. This is critical to prevent nozzle clogs.
- Prime the Lines: Follow the on-screen prompts to ensure water and abrasive are flowing correctly before hitting ‘Start’.
Shut Down Instructions
- Clean the Workspace: Rinse the cutting area and the interior of the Wazer with low-pressure water to move used garnet into the collection bins. Do not rinse any garnet down the drains.
- Clear the Tank: Check the used abrasive collection containers and empty them if they are full.
- Power Down: Turn off the Wazer and the high-pressure pump.
- Log Your Use: Record your cut time and abrasive usage in the shop log to ensure the machine stays maintained.